en
de

Deutschland

Italia

España

United Kingdom

United States

Lietuva

APS 2 / APS 3 Battery Pack
Manual
APS 2 / APS 3 Battery Pack

Table of contents

Battery Charging

  1. Install the rechargeable battery (1) along the guides until stop into the charger’s (4) slot. Charger will be supplied with your Pulsar device or bought separately.
  2. Spot A on the battery and spot B on the charger should match (see image).
  3. You can charge two batteries at the same time - a second slot is designed for this purpose.
  4. Connect the plug of the USB cable (not included) (7) into the port (5) of the charger (4).
  5. Connect the other plug of the USB cable (7) to the jack of the mains charger (3).
  6. Plug the mains charger (3) into a socket 100-240V (6).
  7. LED indicator (2) will show battery charge status (see the table).

(2) LED Indicator*

Battery charge status

Battery charge from 0 to 10%. Charger connected to the mains power supply

Battery charge from 0 to 10%. Charger not connected to the mains power supply

Battery charge from 10 to 20%

Battery charge from 20 to 60%

Battery charge from 60 to 95%

Battery completely charged. Charging will automatically stop. The battery can be disconnected from the charger.

Battery defective. Do not use the battery!

* Indication shows the current battery charge level for 30 seconds if the APS charger is not connected to the mains. Once connected to the mains, indication shows current battery charge level permanently. LED indicators also glow showing charging process.