Installing Battery Pack in the IR Illuminator

The IR illuminator Pulsar Digex S is powered by APS2 (or APS3*) battery pack.

1. To install the battery in the IR illuminator, turn the battery cover (1) counterclockwise and remove it.
2. Install the battery into the battery compartment (2) along the special guides in the IR illuminator body designed for it.
3. When properly installed, the battery is fixed in the battery compartment (2).
4. Close the battery compartment cover, turning it clockwise.

The illuminator is equipped with LED indicator (3) making possible the current battery level monitoring. Indication modes are in the table below:

Indicator color (3)	IR Operating Mode
	The illuminator is on, power supply 3.2 - 4.2 V
	The illuminator is on, power supply <3.2 V, an approximate operating time before the IR illuminator turns off is 30 minutes
-	The illuminator is off

*Sold separately