United Kingdom

United States


Helion 2 XQ
Helion 2 XQ

Table of contents

External Power Supply

The thermal imaging scope can be supplied from an external power source such as Power Bank (5 V).

  1. Connect the external power source to the USB port (4) of the device.
  2. The device will switch to operation from the external power supply and the IPS7 Battery Pack will be gradually recharged.
  3. The battery icon will appear on the display showing the percentage charge level.
  4. If the device operates on external power supply but the IPS7 Battery Pack is not installed, the icon  is shown.
  5. When external power supply is disconnected, the device will switch to the internal IPS7 Battery Pack without powering off.

Warning! Charging IPS7 / IPS14 batteries at air temperatures below 0° C (32° F) may reduce battery life. When using external power, connect the Power Bank to the device after it has been turned on and working for several minutes.