en
lt

Deutschland

Italia

España

United Kingdom

United States

Lietuva

Krypton 2 FXQ/FXG
Manual
Krypton 2 FXQ/FXG

Table of contents

Installing the Monocular on to the Attachment

The Pulsar 3x20 B monocular (23) (available separately) allows you to transform the attachment into a hand-held thermal imager with 3x magnification.


1. Align the protrusions on the monocular (23) on the side of its lens with the grooves of the mount (18) of the attachment.

2. Turn the monocular clockwise to secure it on the attachment. The recommended position of the clamping screw (24) is at the bottom (see Figure).

3. Turn on the attachment by pressing the ON/OFF (8) button.

4. Adjust the eyepiece diopter ring (25) until the symbols in the display are sharp.

5. Loosen the screw (24) with an Allen key S3.

6. Align the display to the center of the image in the monocular by tilting the attachment in the required directions.

7. Lock the monocular in the chosen position by tightening the screw (24) until it stops (clamping force – 2.5 Nm/ 22.13 in-lbs).

8. To remove the monocular, turn it counterclockwise and disconnect from the attachment.