en
lt

Deutschland

Italia

España

United Kingdom

United States

Lietuva

Krypton 2 XQ/XG
Manual
Krypton 2 XQ/XG

Table of contents

Battery Charging

The device is supplied with a rechargeable IPS7 Lithium-ion Battery Pack which allows the device to be used for up to 11 hours. Charge the battery before first use.

The icon  in the status bar will flash when the battery is low. The battery needs to be charged.


Option 1

  1. Install the IPS7 battery (4) in the battery compartment of the device.
  2. Connect the USB Type-C cable (20) to the USB Type-C connector (10) of the device.
  3. Connect the other end of the USB cable (20) to the Power Adapter (21) by removing the USB Type-A adapter.
  4. Plug the Power Adapter (21) into a 100-240 V socket.
  5. Wait until the battery is fully charged (indication in the status bar:  ).

If the device is off, the LED indicator will display the battery charge status:

LED indication

Battery status

Battery is charging

Battery is charged

Defective battery. Do not use the battery!

-

The device is switched on

Option 2

Charging

Step 1. Install the battery into the charger

  1. Move the lever (3) to the open position .
  2. Install the Battery Pack (4) into the charger.
  3. Lock the battery (4) by moving the lever to the closed position .

Step 2. Сheck the current battery level

  • Upon installation, a green LED indicator on the charger will start to glow and begin flashing:

- once if the battery charge ranges from 0% to 50%.

- twice if the battery charge ranges from 51% to 75%.

- three times if the battery charge ranges from 76% to 99%.

  • When the indicator is continuously green, the battery is fully charged. Disconnect the charger from the mains and disconnect the battery from the charger.
  • If the battery charger indicator is constantly red when the battery is inserted, the charge level is probably below the permissible level (the battery has been in a discharged state for a long period of time). Leave the battery in the charger for a long period of time (up to several hours), then remove and reinsert.
  • If the indicator begins to flash green, the battery is good.
  • If it continues to show red, the battery is defective. Do not use this battery!

The LED indicator will display the battery charge status:

LED Indicator

Battery Charge Status

Battery is empty

Battery charge level is from 0% to 50%

Battery charge level is from 51% to 75%

Battery charge level is from 76% to 99%

Battery is full

Step 3. Сonnect the charger to the mains supply

  1. Connect the plug of the USB Type-C cable (20) with the attached MicroUSB adapter (22) to the USB socket (19) of the charger.
  2. Connect the other end of the USB cable (20) to the power adapter (21).
  3. Plug the power adapter (21) into a 100-240V socket.
  4. When the indicator is continuously green, the battery is fully charged. Disconnect the charger from the mains.