en

Deutschland

Italia

España

United Kingdom

United States

中国

Lietuva

Talion
Manual
Talion

Table of contents

Mounting on the Rifle

To ensure accurate shooting the Talion riflescope should be properly mounted on the rifle.

  1. Secure the support* (22) on the riflescope mount (21) using a Allen wrench/hex key* and screws (23)* (clamping force – 4 Nm/35.4 in-lbs).
  2. Choosing the position of the mount helps to ensure the correct eye relief, depending on the type of rifle.
  3. Install the riflescope with the mount on the rifle and check if the position is suitable for you, then remove it.
  4. Unscrew the screws (23) halfway, apply some thread sealant onto the thread of the screws (23) and tighten them fully (clamping force – 4 Nm/35.4 in-lbs). Let the sealant dry for the time specified in the instructions. The riflescope is ready to be installed on a rifle and to be zeroed.
  5. Before using the riflescope (especially for hunting), follow instructions in the Zeroing section.

*Sold separately or included in the package. The type of the mount and screws depends on the device model.

Mount

Screws

Weaver U

2 screws М6х18

Weaver USQD

2 screws М6х20

Weaver LQD

3 screws М6Х12