en
it

Deutschland

Italia

España

United Kingdom

United States

Lietuva

Merger Duo
Manual
Merger Duo

Table of contents

USB Connection

  1. Connect one end of the USB cable to the USB Type-C (17) connector of the device, the other one to the port on your computer using a USB Type-A adapter.
  2. Turn the device on with a short press of the ON/OFF (4) button (device that has been turned off cannot be detected by your computer).
  3. Your device will be detected by the computer automatically; no drivers need to be installed.
  4. Two connection modes will appear on the image: Power and Memory Card (external memory).
  5. Select connection mode with UP (7)/DOWN (8) buttons.
  6. Confirm selection with a short press of the MENU (9) button.

Power

  • In this mode, when a computer is used as an external power supply, the icon appears in the status bar. The device will continue operating and all functions are available.

  • The Battery pack installed in the device is not being charged!
  • A battery recharge feasibility depends on your computer's USB port.

Memory Card

  • In this mode the device is detected by the computer as a flash card.
  • This mode is designed for work with the files saved in device's memory. The device's functions are not available in this mode; the device turns off automatically.
  • If video recording was in progress when connection was made, recording stops and video is saved.

USB Disconnection

  • When the USB is disconnected from the device connected as the Power mode, the device continues operating from the rechargeable batteries if they are sufficiently charged. 
  • If the device is in Memory Card mode and is disconnected from USB, the device will remain on.