Manuals | Pulsar

Connect one end of the USB cable to the USB Type-C (17) connector of the device, the other one to the port on your computer using a USB Type-A adapter.
Turn the device on with a short press of the ON/OFF (4) button (device that has been turned off cannot be detected by your computer).
Your device will be detected by the computer automatically; no drivers need to be installed.
Two connection modes will appear on the image: Power and Memory Card (external memory).
Select connection mode with UP (7)/DOWN (8) buttons.
Confirm selection with a short press of the MENU (9) button.

In this mode, when a computer is used as an external power supply, the icon appears in the status bar. The device will continue operating and all functions are available.
The Battery pack installed in the device is not being charged!
A battery recharge feasibility depends on your computer's USB port.

In this mode the device is detected by the computer as a flash card.
This mode is designed for work with the files saved in device's memory. The device's functions are not available in this mode; the device turns off automatically.
If video recording was in progress when connection was made, recording stops and video is saved.

When the USB is disconnected from the device connected as the Power mode, the device continues operating from the rechargeable batteries if they are sufficiently charged.
If the device is in Memory Card mode and is disconnected from USB, the device will remain on.